Paintless Dent Removal on Rails and parts of the car where you can’t get behind the panel and push a dent out. We use special glue, apply on glue tab, after glue hardens we use mini lifter or slide hammer to pull tab out. It might sound easy but sometimes it takes a lot of time and attempts to pull dent several times to actually make panel flat and even. and it’s because you can’t control glue pulling process as well as you can control pushing dent out from underneath. Usually after dent is pulled out it requires to knock a high spot down to reach a pre accident condition.
After any paint work buffing is necessary. You can’t skip that step. Even if you have the most advance spray booth and it’s clean and maintained properly; even if painter is skilled you would still need to finish that panel with buffing and sometimes sanding down little dirt or run spots that occurred in painting process. We never undermine this procedure and execute on it. The best equipment and materials are used.
